Categories

Hot Products

News

Method For Installing Motor Of Cold Rolling Mill
Sep 04, 2018

Method For Installing Motor Of Cold Rolling Mill


As the main power source of the cold rolling mill and the power supplier, the installation place of motor will have an impact on the operation of the cold rolling mill. So what are the methods for the cold rolling mill motor during the installation process? Or what are the principles for the installation for the motor of a cold rolling mill? The technicians of cold rolling mill, cold rolling machine, cold rolled ribbed steel machine, cold rolled ribbed steel production line produced by Gongyi Jindi Metallurgical Equipment Co., Ltd explain the cold rolling mill motor installation method in the following.

       

1. When the cold rolling mill motor is installed, the base is installed first generally, and the initial alignment is performed, and then the stator is installed, and then the rotor is installed.

       

2. For a motor with a small weight, consider inserting the rotor into the stator first, and then inserting a soft material such as a rubber asbestos board in the inner wall of the stator, and then installing it by the crane at the same time.

       

3. The rotor can be threaded into the stator at other locations.

       

4. If the motor base is lower than the indoor floor by a certain distance, the “core-through” cannot be realized in the installation position, and the crane does not allow the whole motor to be installed. In this case, it is necessary to pre-stitch the stator with a woodpiece, and then wear the core.

       

Gongyi Jindi Metallurgical Equipment Co., Ltd kindly reminds us that in the process of installing the cold rolling mill motor, the key is to ensure the internal cleanliness and pores are correct. In general, when the position of the motor in the gear carrier and the cold rolling mill is determined, the position of the motor is corrected by taking the coupling as the measuring position. When looking for the right time, we must take into account both the level of the motor and the end face jump of the take-over.


Tel: 86+13674996266, 86+37164388822

Email: rachellee@jindimachine.com  

Website:http://www.jindimachine.com 


  • QR CODE
  • facebook